Minor change to FocusLynx driver (Optec Leo support) #34037
I was able to get things to work with the Optec Leo focuser/FocusLynx
combination by adding just two small entries to an array of focuser
definitions in the (very well-written) FocusLynx driver. The change
passed the autofocus test, as well as various manual motion tests.
Not being a full-fledged INDI developer, does anyone know how I
would go about sending this information to the development team,
short of a pull request? It's just two lines in focuslynxbase.cpp.
The source information for the changes comes from Daniel and
Jeff at Optec.