Hi!

I'm experimenting during the day with Ekos Scheduler, but I cannot make it run. THis is what I do:
- I select an object that is (should be) above the horizon, even thugh it is daylight
- I select a sequnce file, created with the capture module.
- I select only two modules, Track and Align, since I don't have motorfocus yet
- I set it to start ASAP, or Force Now, or as in image below, to a set time.



Clicking the Start Scheduler poduces the output "Found candidate job M57", but then nothing more happens. What's going on here? Is there a daylight constraint somewhere? Did I miss to fill something in? Mount is not parked, but slewed to the approximate location of M57.

Magnus

It does not run during daylight hours unless you set it to "Force now". After you add an object, you cannot change its setting unless you double click it and it says "Editing job #1..." then you make the changes and click the check mark above the job. Hmmm maybe that's not quite as intuitive.. I'll see if I can improve it.