Hi everyone,

I updated and all my devices do connect. Thank you Jasem!

But there is still a Problem with the Setso Senso. I did a calibration with PrimaLuceLab-Software. Then connect it to Ekos. The absolute and outmost Position was 81625. Then i want to let it go 5000 steps inside. But it went more then 5000 steps. I have to stop it manually. Otherwise i think it would have go to 0 or passes that. I have added a log file. Let me know what i should do now. Thank you!

I can not get the Sesto senso driver to work any more. This is for version 3.1.0. After it is calibrated with the Sesto senso windows app I can connect to it and it registers the correct Absolute position, but if I tell it to Focus in 100 steps it will move in and not stop and keep trying to go, even after the focuser has reached the end of the draw tube. If I tell it to focus out it will also also focus <em>in</em> and not stop. Version 3.0.0 seems to work fine.

I tried Jasem's advice on disabling auto connect so the debug log will work but it will not let me enable Debugging. I tried replacing the Sesto Senso INDI driver with the 2.9.8 version but that will not work at all.

I will check this tonight, I see some issue with the log and will hopefully get a release out soon.

Ok I believe I fixed the remaining issues. Please git pull or wait for nightly. I am using newer commands which require an updated firmware.. this was causing some issues.

I would be glad to try it but I am on a OSX version. So no nightly builds. Is it a file that I can manually replace? If so send me a link and I will give it a try.

Hi Jasem,

thanks for the support!

I have downloaded the latest build and updated StellarMate. Then I tested the Sesto Senso (after a calibration in the PrimaLuceLab Software). At my first test i defined three Presets. Then I want the Setso Senso to go to the second preset (that means move from the outmost Position of 81269 to 62000). But the Sesto Senso passes 62000 and moves all the way in (it runs to 0 and then runs further; after a manual stopping it stops running).

With my second test (after a calibration; the outmost Position was 83278) i want to focus in 2500 steps. But the Sesto senso moves more then 2500 steps and stopped only because of my Manual stop. Pleas find enclosed the logfile of this test.

I have the latest firmware (2.1) on the Sesto Senso.

Yes, this is the same behavior that I was getting. It just would not stop unless I hit ABORT or pulled the power from the focuser. I do not have access to the latest build, but I am using what is distributed in 3.1.0 for OSX.

StellarMate still didn't get this update since this change is in nightly (Testing) PPA and not the stable PPA.

I have downloaded the latest nightly (04.03.2019) on my laptop.

All my equipment is connected to StellarMate (which i also updated yesterday) and StellarMate is connected to my HomeWiFi to which my laptop is connected.

For the test I started KStars / Ekos on my laptop and managed the Sesto Senso from there. In my mind I tested the latest nightly with this configuration. If that is not correct please advise me what i should do for testing it correctly. Thank you!

I restarted the INDI Nightly build , so in a couple of hours try to update from nightly and test. But based on the log you sent, it was definitely not using the latest changes I made.

I have downloaded the latest Nightly on my laptop (windows), but it is still the same. Do have to download the latest Nightly also on StellarMate (if so, how can I do that and how can I go back to the latest stable version)? What else should I do?