ST4 Relays NC for guiding

My telescope expects normally closed relays for operation on the guide inputs. Is there
any control over the ST4 port in the Ekos guide module for NC vs. NO operation?

Thanks,
Matt

Hello Matt,

I don't think so. It's an hardware incompatibility. You have to create you're own electronic converter. Between your mount and your camera guide.

Sébastien.

I had some Linux guiding software a few years ago which allowed the user to
set the polarity of the ST-4 switches. I was hoping that could be added to either
the camera device driver or as an option in the built in guiding for Ekos.

Thanks,
Matt