Hi!

I tend to use 2 different ASI filter wheels, one with 7 positions (for RGB and NB filters) and one mini, with 5 pos (for photometric filters). However, both are identified as ASI EFW.

Now, I have saved the configuration in the Indi window. And then when I switch filter wheel, it does not adapt to the correct number of filters. So right now, I have the mini with 5 filters - but in Ekos, I have 7 filters.. THat is less of a problem. But previously, when Ekos told med I had 5 and then I switched to the 7-pos filter, it did not update in Ekos so I could not use filters 6 and 7.

How do I handle this? I'd prefer to have 2 different equipment profiles for them.

Magnus

+1, I was hit by that, too: I have two connected at the same time, and numbering may change depending on where they are plugged in which messes up filter names and filter offsets....

Same will happen with EAFs