Hi as far as the windows protocol is concerned, i have not tried it. there is one issue - i do not use the temperature sensor,and i do not use the display. if you do, there might be a problem because the temperature sensor is connected to A4 in the original sketch, which is also a I2C pin for the display. i changed that to A0, but as said, i do not use the display or the sensor. i can send you my modified sketch. this works fine with EKOS ...
yours
wolfi

Thanks Wolfi,

The display and sensor work, the sensor is on A3 now, this had been changed in the Arduino sketch by Hansastro.
I will have to test on Ekos, so far I am a Windows user, but I want to escape!
But I need to connect a camera first, or Ekos will not start.

Regards,
Albert

hi!
as said before, i did not encounter that problem with Linux...
yours
wolfi

Correct. The Indi Moonlite (an others) driver retries and that solves the problem (or has a time-out) The original Moonlite driver on Windows does not wait long enough for the communication to start.

Rgrds,

Paul

My remote observatory is working with Windows7 and ACP now. For the future I don't want to rely on Windows10, so I'm planning to test Linux in my home observatory. Which Linux flavour is best for use with Ekos? So far I only have some experience with Mint 19.

Regards,
Albert

I created a driver for the OnFocus stepper version. Still need to do some testing. Can onlt test against an Arduino with the firmware loaded, but no motors attached, but seems to be communicating ok with the firmware. Probably ready by next monday (or earlier is things proceed as expected)

Need to set up this complicated GIT stuff (and re-create an acount) to get it in the Indi version? (Other solution welcome as well)

Regards,

Paul

That's great Paul, thanks!
I will try to test it as soon as you put it on GitHub.
The OnFocus controller has proven its use under Windows in my remote observatory, so I prefer to use that.

Regards,
Albert

Just a few questions:
Are you using "Set Half Travel Position". Not really sure what it is supposed to do, and there are inconsistensies in the ASCOM driver with regards to the maximum position.

I haven't looked at the backlash setting yet. That seems to be implemented in the ASCOM driver, since there is no command for in firmware. Suppose after moving just need to apply the configured #of backlash steps?

Rgrds, Paul

No, I don't use "set half travel position" My focus point is around position 3000.
I just focused roughly by hand, the focus position counter was around 3000 then, after that I used autofocus. (FocusMax4 under Windows).
That starts from focus and then moves the focuser outward and inward and measures the diameter of the out of focus star image.
Only very little movement is needed.

And I don't use Backlash as well, I use a 200 step motor directly on the fine focus knob of my Crayford style focuser, assuming there would be no backlash that way, and that has always worked for me.
But you would just add the backlash steps to the number of steps when changing direction I guess.

Regards,
Albert

Paul

Super that you help use with this
I do not need backlash comp. as well. It looks like i have the same setup as Albert
When its available i can test it ,let me know.
i think i need short description how to install your build driver
Anyway iam very happy already, lot of kudos from my site

Chris