Took a little longer than I anticipated, those last few details cost me more time that I thought.
I will push my changes to the repository later today so version 1.4 should be available via the nightly build within a couple of days.

I considered putting the Calibration on its own settings page but since the focuser is a simple device I put the options on the Main page.
Once you start the Calibration process you need to finish it. I have not included an Abort option on purpose as it leaves the focuser in an undefined state.
I also only display the Move In/Move Out/Stop buttons when the Calibration process requires them. These are not required for normal operation and I think they are a little dangerous as they have to be able to go beyond the current Min/Max values.

Thank you very much! That sounds great! I will test that as soon as possible and give a feedback.

Changes have been approved so 1.4 will be in the next nightly build.
Let me know how it goes.

Great work. Thank you very much.

Now I just need a way to fix the compatibility issues between the weather conditions and my available spare time.

Hi Rishi,

I tested the version 1.4 indoors and everthing works fine! The calibration works easy and perfect. I can focus in and out to the correct absolute position.

Because I also have these compatibility issues between spare time and wheather conditions it maybe take some time until I can test it with autofocus outside. But I am sure it will work great!

Thank you for that awesome work!!

Best regards

Nils

When will this be included in a stable build?

Great to hear it works. Should have some clear skys here tonight so hopefully I can give it a real test.

I don't know when it will be added to the stable build. Probably best to ask Jasem when that happens.

Probably by the end of June.

Thank you for this great update.

I have only just noticed that the indi driver does not show the temperature sensor readout anywhere.
Is there any way that can be included?

I can confirm that this new flavour of the driver works very well, including the initialization procedure.
I noticed the temperature is only displayed if the sensor is plugged, which seems logical. And it is updated every 10 seconds or so.
Thanks a lot for that great work.

Where is the temperature displayed?

Can you share a screen capture?

That's why I posted the previous post.

Here is the requested screenshot.