I've noticed recently... While running s schedule containing a sequence with autofocus enabled. It takes the first image or 2 then starts focus.
Focus finishes fine but the scheduler overview tab (setup tab) shows focus status is in progress. Its stuck at this point. As a workaround, I go to the focus tab and click autofocus. Then when it finishes the scheduler gets going again.
Any ideas what I'm doing wrong? This used to work fine until I updated everything recently.
Eric was working recently on focus states. I suppose it might be related. Is this reproducible with simulators? If yes, please attach an appropriate ESL file that replicates this.
Good idea, I'll give it a go. I did have "In-Sequence HFR Check" set to 2 for some reason. I changed this to 5 and it stopped happening. I think I should probably delete all my local settings and start from scratch some day
Derek