Thanks for posting that, its as I remembered, I think one of my laptops is already setup for it so that should be quiet doable. Have you tried with a smaller polling rate since the upgrade to see if that works ok.
Also in the UI from a web browser if you type the following commands you can check the current version of the firmware.
1zv? to check firmware of RA drive
2z?? to check firmware of Dec drive (do not need separate connection to it)
thanks, I’ll try those commands and see what they say. With the new firmware loaded the driver works perfectly now. Still a very occasional timeout error but hardly any, neither at 1 second now it seems.
Again, Jerry over at Cloudynights is busy designing basic goto UI, to replace the one that Richard made. He says he has used a lot of code from the Indi driver, but does not understand everything about it yet. Is there any way he can get in contact with you guys, especially with Jasem. Would be great if you guys can assist him a bit, so that we get some goto functionality right from the phone/tablet.