Check out building INDI Guide .

Thanks I followed a previous link to this. I have built a new core using the cmake option. Just finishing breakfast will setup mount and send you the log
Paul

OK New log

First I apologise for 'sticking my nose in' but the 0 value from microsteps per worm revolution is surely only required if there is some sort of PEC on the mount (highly unlikely for an Alt/Az)
So maybe not a major issue
Paul

This is not latest code, are you sure you ran "sudo make install" after you built? The latest version is 1.7

Possibly not I’ll rerun from there

Sorry this looks different just generated a warning message

Did you try to issue GOTO?

No the go to seemed to be fine, only issue I noticed was the tracking light flickers off and on.
I will run a longer session with tracking and go to with the logging on and post it through
Paul

Hi Full log with goto and tracking

Looks like there was some communication error soon after? mount not responding?

Hi Jasem
Yes for connecting I set the Skywatcher WiFi dongle into station mode (as per another post on the original error message) seemed to connect ok but I’m suspicious of it’s reliability. Would prefer to use EQMOD cable but could not get it to connect (even tried swapping Tx with arc) can’t use normal WiFI connect to host as the Pi is already connecting to it’s own local host.
Think I’ll try to invest the EQMOD cable that’s available for the AZ GTi, what do you think?
Paul