I am trying to setup my new AZ-GTi mount with astroberry latest version but am not sure, which driver to use. I updated the mc-firmware to 3.22 right_arm ,don't use a wedge, the Raspi and the mount are on the same WLAN.
As far as i see, there are 6 different drivers: Az-GTI, EqMod, Skywatcher Alt-Az, Skywatcher Alt-Az Wedge, Synscan and Synscan Legacy.
I tried all drivers but either I cannot connect over ethernet udp port 11880 or cannot find where to tell the driver that i am not using a wedge.
Can somebody help please?
Similar questions from my side. Just I am using the EQ-direct cable (yes, the specific one for the AZ-GTi) with the EqMod driver. Manual control works fine, just wondering how to set AZ-mode in the driver.
Skywatcher Newton 200/1000, Sharpstar 60ED, Canon Lenses
Skywatcherr EQ-6 R, AZ-GTI
StellarMate @ Raspberry Pi 3B+
ASI 183 MC Pro
ASI 290 MC guiding cam on APM 60 ImageMaster
Sesto Senso 2 Focuser + Astromechanics Canon Focuser