Hi!

I updated today from SM 1.7.4 to SM 1.7.5 and my Sesto Senso 2 focuser stopped working. It was working perfectly fine today just before the update.

When I try to move the focuser or even attempt calibration, I get the following message on the console:

12023-02-03T03:43:35: [ERROR] Required ("reg":{cmd":"MOT1 "CAL_FOCUSER""GoOutToFindMaxPos")} failed: ("res":(cmd": (MOT1*:#"?* 'Error: invalid command !!!}

Any thoughts?

Thanks!

Is focuser updated to latest firmware from primalucelab?

Same problem.

Stellarmate 1.7.5
Firmware updated

This is the log:

2023-02-06T12:37:56: [ERROR] Required {"req":{"cmd":{"MOT1":["CAL_FOCUSER","GoOutToFindMaxPos"]}}} failed: {"res":{"cmd":{"MOT1":{"?":"Error: invalid command"}}}}
2023-02-06T12:37:44: [INFO] Start Calibration
2023-02-06T12:37:20: [INFO] Device configuration applied.
2023-02-06T12:37:20: [INFO] Motor currents applied: Acc: 7 Run: 7 Dec: 7 Hold: 3
2023-02-06T12:37:20: [INFO] Motor rates applied: Acc: 1 Run: 2 Dec: 1
2023-02-06T12:37:20: [INFO] Loading device configuration...
2023-02-06T12:37:18: [INFO] Parameters updated, focuser ready for use.
2023-02-06T12:37:18: [INFO] Sesto Senso 2 is online.
2023-02-06T12:37:18: [INFO] Sesto Senso 2 is online. Getting focus parameters...
2023-02-06T12:37:18: [INFO] Firmware version: 03.03.07
2023-02-06T12:37:18: [INFO] Serial number: SESTOSENSO22030

That does appear to be the new firmware, there were some issues:

www.indilib.org/forum/focusers-filter-wh...-github-release.html

But it is supposed to be resolved with an updated indi driver.

Hi Thomas,

I have not updated the focuser’s firmware. Just Stellarmate.

Thanks,

Hi Thomas,

I have not updated the focuser’s firmware. Just Stellarmate.

Thanks,

It stopped working for me after the stellarmate update.

Then I did the firmware update (hoping to fix it), but the calibration fails.

After a calibration with the primalucelab program (play under windows 10) the focuser moves without errors even in ekos (I dont' have tried the calibration under ekos after calibration under windows)

Hi,

I have the same problem

after reinstalling from scratch SM 1.7.5.

Maybe a bit late but I ran into the same problem. Updated my Sesto Senso 2 firmware using the Primaluce Play software (on windows). Works well now on my Stellarmate and Indi drivers.