I am new here and to this software, and having it all set up there is one bit of kit I have that I can’t control via INDI, my Pegasus ultimate power hub, there is a driver for there DMF focus controller but no the hub, or am I missing it somewhere....any ideas..??
Thanks in advance
That would be great, with a driver for this I could remote control my whole set up, the Ultimate power hub is superb and would not be without it, like i said I can control all other devices I have and as this controls the switching on and off of all my devices, focus control, and 6 port USB hub, temperature and dew point graphs and full dew control, all controlled from my PC, it is a must in my set up.
Look forward to any news on this
The short answer is no, I contacted them a week or so ago, and they said they were still working on it...I am waiting for it too and was hoping for it this winter....but don’t look like it’s going to happen...
Stellarmate OS on Raspberry pi4b
Skywatcher EQ8 pro, on steel pier
Takahashi FSQ85, FS60cb & Meade 8” SCT (de-forked)
Starlight Xpress SXVR H18, SXVR M25c, Lodestar x2 Guide Camera
Pegasus Ultimate Hub V2 for all USB & Power
Pegasus focus motors on all scopes
I currently use a Sotobeams fused 12v powepoler block to avoid cigarette socket connections and a 7 outlet usb powered hub. The Pegasus does much more including dew heatrr and focuser control. Making the bits and leads at the mount even less of a spaghetti junction. I use a Raspberry Pi with Stellarmate installed for the equipment control with Kstars and Ekos
In discussion with Pegasus this morning they confirm they are working on Indi drivers so