Hi everyone,

I'm experiencing some issues since I upgrade to kstars 2.9.4.
I use the scheduler to perform my imaging sequences, here is how it's set up :
I set the target and give a fits file for alignment ;
I checked the steps : Track, Focus, Align and Guide
I gave a sequence file.

When the scheduler is launched every thing works fine until it try to start the imaging sequence. The imaging sequence don't start ant send me this message :

Manual scheduled focusing is not supported. Run Autofocus process before trying again.
In the sequence I checked : "Guiding deviation <" ; "autofocus if HFR >" ; "Refocus every" and "Meridian flip if Ha >"
If I manually launch an autofocus then I can start the sequence (but an autofocus was already done by the scheduler...).

So I tried to upgrade Kstars to 2.9.5 and indi to 1.7.1. And, well, it's getting worse, now, even if I launch an autofocus manually the sequence don't start sending me the same message as before. The only way I found is to unchecked the autofocus boxes in the sequence parameters...

I think I missed something... :)

Regards,

Davy

Read More...