Thanks again Rishi!

I had that Hold parameter set to Medium/24 and I changed it to Medium/15. I have a Zwo OAG, ASI290MC, SX filter wheel and QHY183M in my train so I think that this would be a medium gear.. am I right?

It seems that now is working right without any overheating . I put the temperature probe stuck to the focuser case and is not detecting any temperature raise...

The problem now is exactly that: the temperature sensor is not read by INDI driver. Only is read when you start the drivers and connect the gear, but temperature doesn't change. I tried to keep the sensor in my hands a couple of minutes to warm it and driver is stiil at its initial read. Then I disconnected and stop the driver and restart and reconnect and at this moment the sensor read the temperature increment.

it seems that the driver (or the focuser itself) is not reading (polling) or sending any temperature data no more than at starting time.

Someone has experienced the same?

Thanks

Paco L.

Read More...