Linux noob(ish) here.

I can't find any clear instructions on how to do this anywhere, so I was hoping that the collective expertise could help.

I have just purchased an Altair Hypercam 294c and wish to connect it to my RPi4 running Astroberry 2.0.1 (and possibly StellarMate at some point, so hopefully there's some commonality)

The excellent chap at Altair, Ian, said that I would need to download and run the AltairCapture script to set up the drivers. I have done this..... or at least I think that I have. I downloaded, extracted and ran the unzipped .sh file, but no feedback is provided, so how do I find out if it is actually installed?

I'm thinking that I needed to so a sudo from the command line, rather than just double-clicking on the archive, and having the terminal sit for a few seconds before disappearing enigmatically.

Assuming that the drivers have been installed, is it then just a case of plugging the cam in and setting it up in Ekos as the CCD?

Cheers,
Darren

Read More...