@Willem: Sorry, I only just saw your original message. The original INDI driver logic applied the built-in Slow motor preset for the Sesto Senso 2 on connect. The changes I made to expose the motor settings via the INDI driver removed this - so all recent nightly builds shouldn't override the current SS2 settings, even if they were set outside of INDI. So I think the issue is you weren't using a recent enough version of INDI. Unfortunately, the main changes went in immediately after the most recent (v1.8.8) release of INDI in January. So you will need a recent nightly build to see the changes.

@Jasem: I'm on the fence about overriding the SS2 motor settings via the saved INDI values. I was taking the approach that the settings stored on the SS2 flash were authoritative. It is quite possible that users may use the SS2 web interface to fine tune the motor settings outside of INDI. But that said, perhaps the INDI settings should have precedence? I wasn't sure where you typically draw the line when it comes to devices that maintain their own state...?

Read More...