I have a power outage so it is an excellent time to try things out.
I still don’t have the RTC from on order.
I did however try connecting to the StellarMate app this evening. The good thing was that I think it synced up the time. The bad thing is that every few seconds it drops the connection and says that it has a sync error.
The IP that I am connected to on the StellarMate app matches the travel router.
I believe that the travel router is set up on station mode. I have a small Ethernet cable going from the Pi unit and the travel router.
What should the network settings read on the StellarMate app?
Presently I am connected to my MacBook with no issues that I see other than the fact that my battery will run out sometime tonight.
I would like to get the StellarMate App going for times that I will be imaging remotely.