When following your procedure I still run into problems that block me from using the driver.
All goes well until the step where I need to write the park information.
There is no red light next to the part position field and when I try to write the park data, I get an error message that I cannot write parking information while slewing or parking. I also, after a cold start and unparking, seem to be able to park again.
When following your procedure I still run into problems that block me from using the driver.
All goes well until the step where I need to write the park information.
There is no red light next to the part position field and when I try to write the park data, I get an error message that I cannot write parking information while slewing or parking. I also, after a cold start and unparking, seem to be able to park again.