Stefano replied to the topic 'Interface with Home Assistant' in the forum. 7 months ago

hai,

This has to be installed on the Stellarmate host?
Then I have to install docker?
Then can I really full control scope and dome from remote?

regards
Stefano

Read More...

This works if you have only one target.
How to do this if you want to repeat for multiple target.

Target A (seq=B,V,R,I)
Target B (seq=B,V,R,I)
Target C (seq=B,V,R,I)

and again:
Target A (seq=B,V,R,I)
..

It will be possible?
regards
Stefano

Read More...

Stefano replied to the topic 'Trouble with focuser Focuser Boss II' in the forum. 3 years ago

I found this: indilib.org/forum/general/648-is-an-indi...r-boss-ii-exist.html

I try to send some commands via serial COM, and seems to me ok.

I don't know how the INDI interface is implemented.
Why for example is not reporting the correct temperature?
I try to send the command <F1STATUS> and is reporting the correct information.

Is the INDI interface using this command set?
 

Read More...

Stefano replied to the topic 'Trouble with focuser Focuser Boss II' in the forum. 3 years ago

It seems, nobody in the INDI community is using this focuser, so I will go back to window until someone tells me how to use this.

Read More...

Stefano replied to the topic 'Trouble with focuser Focuser Boss II' in the forum. 3 years ago

Attached the log (I now there is a problem with the dome script, but this is an other history)

regards
Stefano

Read More...

Stefano replied to the topic 'Trouble with focuser Focuser Boss II' in the forum. 3 years ago

Hi, thanks for your reply, 
Sure I did the calibration, and that seems to work, but I can't then move the current position.

Moving Absolute position:
2021-05-08T12:28:46: [INFO] Focuser is moving to position 2000 
Moving relative Position:
2021-05-08T12:26:18: [ERROR] Requested position out of bound. Focus minimum position is 0 
Calibrazion:
2021-05-08T12:26:11: [INFO] Setting current position to 0 

Moving Absolute position, is moving the focuser (relative position not) but never complete the command (stay yellow).
I don't know which is the correct model to use in my case.

When I change the Model of the focuser (to test others), Ekos disappear./kill... 

Is really a strange behavior.
Stefano

Read More...

Stefano created a new topic ' Trouble with focuser Focuser Boss II' in the forum. 3 years ago

Hi, 
I'm just migrating from a Windows PC ASCOM running configuration to a Stellarmate(INDI) raspberry pi 4 setup.

Everything seems to be working, with the exception of the focuser.

I Setup FocusLynx, Model FT Motor PDMS, connected with Serial/USB interface.

But I can't see the status: position, temperature. And I can't move them.

Attached the INDI config and the config (running) on windows.

Any ideas?
Please help
regards
Stefano



 

Read More...