TLDR: What are AVX or other Celestron users doing to have a fully remote control telescope?

My connections are pretty typical:
* ASI290 to ASI533 via usb2
* ASI533 to stellarmate (raspberry pi w/ kstars) via USB3
* GPS to stellarmate via usb2
* Mount to stellarmate via usb2 on the hand controller.

When powering up the AVX, the hand controller asks me to begin alignment and INDI says "Mount is NOT aligned. You must align the mount first before you can use it. Disconnect, align the mount, and reconnect again." I see this has been discussed before (eg. thread 7233 ). What I'd like to do though is power everything up with my remote control power switch, wait a couple of minutes for my stellarmate to boot, then use kstars/indi to perform the alignment.

I didn't see anything about this in the AVX manual ; what am I missing?

Read More...