Hi
I’m just at the point in my learning curve where I’m trying to improve my calibration frames.

From what I can tell for a cmos based camera (in my case a sony a7rii) I need darks, flats and dark flats (rather than biases). So I’ve got myself a light panel and have used the flats wizard to take flats around 8000 adu. Camera is 14 bit so I believe I need to have values around that and the frames captured seem ok.

Having done that I thought I would get the other wizard on the capture tab to add dark flats to the job queue after I’ve added flats. It works adds the dark flats to the queue, then I set it going, it works out the exposure takes the flats and immediately starts taking the dark flats. However there is no pause between the two to enable me to make things dark.

Is there some way of putting in a pause between the two jobs ? Or is there something I’m missing?

Regards

Nigel

Read More...