Kyle replied to the topic 'Update causes firmware error' in the forum. 3 months ago

I had the same issue when I updated via the updater app today. I didn't check here first but I just ended up downloading a new image to get everything back up and running. Good to know about being able to copy ver a boot partition if this happens in the future.

Read More...

Kyle replied to the topic '1.7 64bit - ASI120mm-mini not seen' in the forum. 7 months ago

Curiously enough, tonight everything worked as expected. The asi120mm-min connected no problem. Nothing was updated or changed, so I'm a bit baffled but happy everything seems to be fine.

Read More...

Kyle replied to the topic '1.7 64bit - ASI120mm-mini not seen' in the forum. 7 months ago

After a bit more fiddling I believe the issue may stem from my Pocket Power Box Adv Gen2.

If I unplug PPBA from the Pi with it turned off and then plug everything directly into the Pi and boot up....I can start indi servies which is able to detect everything just fine.
I have auto-connect turned off. At this point, I can plug my PPBA back into the Pi and the other gear back into the PPBA. Then I can go through and connect each piece of gear within the indi control panel.

However, if I stop indi services and then start them up again, the ASI120mm-mini no longer shows up again.

Jasem, I will check when I get back home tonight.

Thanks, Max! I will try your solution as well. Do you have PPB too?

Read More...

Kyle created a new topic ' 1.7 64bit - ASI120mm-mini not seen' in the forum. 7 months ago

I recently upgraded my Rpi4 to the 8GB version so I decided to give 64bit Stellarmate a try. No matter how I connect my 120mm-mini (the newer one with the USB-c)- Directly to the Rpi4, powered hub, or the ASI533 Hub,., indi doesn't see it.
It sees my ASI533 just fine as well as all my other gear.

My older Rpi4 2GB version running the 32bit version of Stellarmate sees it just fine. Same cables.

Has anyone else run into this with the 64bit version?

Read More...