Don't know about anyone else... but had a chance to get out tonight as it was clear, and when trying to GoTo (via KStars to Caph to check the alignment out, the tracking in KStars simply stopped about 1/2 there and the mount quit responding. I disconnected the EQ6R-Pro and then connected it back, and ti continued slewing to the target and was able to do an alignment with it.
Then, I decided to target NGC_133. Gets in the general area, and then when it is trying to complete the alignment, it can't as it does not appear to be slewing the mount to change the alignment.
Power the entire system down, start it all back up, and it starts and runs OK... UNTIL I have to go out to do some weight movement for the RA. Try to do an alignment again after this and rinse and repeat the above cycle.

Then to top it off, the guiding (which I have configured to use EQMod) for the DEC went from a fairly steady 0.23 to over 23.5 in a matter of seconds and then was bouncing all around... and when checking the scope, it seemed rock solid.

Now, tell me, how exactly do I have "insufficient stars" in the image to do alignment? I've even got both 8.8GB data sets loaded to use for alignment.