Hey,
I'm using a nema17 and a DRV8825 with a breakout board. I connected the pins to the rock pi according to the waveshare scheme. The driver works but when I run some steps the Motor doesn't move a bit, but it only makes a beeping sound like a mosquito (I tried small steps but also up to 10'000 steps). The beeping stops, when the steps are executed, so as far as I understand the enable pin works. I tried delay settings from 20 up to 1000 microseconds but nothing changed. At this point I'm not sure what I did wrong, is there another adjustment which I missed?

Read More...