The bug reported:
bugs.kde.org/show_bug.cgi?id=471373
See this video for more details:
So, if i want repeat all jobs, the "repeat for" should be repeat all jobs, and if you want get a x number of captures from each panel, i set it on the sequency file (*.esq), for example:
i want to do a panel 2x2 and each panel with 10 captures of 30 seconds, and repeat for 3 times.
The procedure should be:
1º) Prepare the sequency 10x30seg.esq file
2º) Set "Repeat for = 3" in job completion conditions
3º) Make the mosaic 2x2 and creat jobs
4º) Run the scheduler and it should work doing:
First repeat:
10 captures from panel 1
10 captures from panel 2
10 captures from panel 3
10 captures from panel 4
Second repeat:
10 captures from panel 1
10 captures from panel 2
10 captures from panel 3
10 captures from panel 4
Third repeat:
10 captures from panel 1
10 captures from panel 2
10 captures from panel 3
10 captures from panel 4
...
And finish Scheduler jobs.
however, now the scheduler its doing:
30 captures from panel 1
30 captures from panel 2
30 captures from panel 3
30 captures from panel 4
Try to do it @Wolfgang Reissenberger
Now the scheduler repeat each job x times before going onto the next job on the queue.
To optimize the maximum captures posible in the night, i mean run each job once then start again from the start of the queue for x number of cycles
with this method, if weather turns bad after a time you would still have some data for all panels of the mosaic.
The objective from this method its not only usefull for astrophotography , its necesary to find variable stars, exoplanets, asteroide... too. Because for this astrophysics study its necesary get maximum number of captures in shortly time.
Thanks you!!