I just updated to SM 1.6 and I have issues with python scripts running raspberry GPIO pins.
I use gpiozero to move a DIY servo dust cap and rpi.gpio to operate an EL panel with PWM commands for flats.
These scripts work just fine if launched in shell and until SM 1.5 also worked in Scheduler, Capture and Dome Scripting modules.
I tried all I could to thoubleshoot this issue, I hope that someone may halp figuring out what it might be... thanks!
Hi Jasem and thanks for the reply,
I use very simple scripts to open/close the cap of the telescope and turning on/off the flat EL light, I attach the code for opening the cap (please unzip as I cannot enclose .py files).
This code is running without issues if I launch from shell with command "python2 open.py" therefore I don't think I miss packages to install...
Thanks for your help!