I'm trying to reset a completed schedule so I can run it again. From what I can see clicking on the Reset button should do this, setting the number of frames to zero and the status to something other than completed. But it doesn't seem to work, there's no change trying to run the sequence just does the end of sequence actions.

This is because I'm trying to learn how to do this, I'm using the simulators to acquire data and that seems to work.

Running on a Pi4 with Raspbian and used the AstroPi3 script to set it up. I'm not sure exactly what version I'm using but it was what the script would have downloaded and built on the 22nd September.

Thanks for any help, hope it isn't something obvious!

Chris

Yes, I had the same problem, and ended up moving the created image files away to a temporary directory. After that, I could reset the sequence status.
There's also a config option 'Remember Job Progress' in Config->EKOS->Scheduler.

Thanks, Remember job progress did the trick.