I did an alignment in kstars and I clicked on "write file" in the align section of EQmod. Then I close kstars
When I start kstars again and connect eqmod it says:
"2015-05-17T15:49:19: Align: current point is 2"
So it seems to load the previous alignment data, but then when I look under Align again
Number of Points/Triagles: 0
Is this intended behaviour?
I can click on "Clear List" and I can see how the EQMod crosshair moves to Polaris so data seems to be loaded
--= human, without Windows™ =--
pls excuse my bad english!