The setting of half step / full step is not stored properly. Even if set to half step and saved the driver is set to full step again when restarting.
This might not look like a big issue but it complicates atomization as you have to start the system manually and correct the setting prior to the imaging.
Skywatcher Newton 200/1000, Sharpstar 60ED, Canon Lenses
Skywatcherr EQ-6 R, AZ-GTI
StellarMate @ Raspberry Pi 3B+
ASI 183 MC Pro
ASI 290 MC guiding cam on APM 60 ImageMaster
Sesto Senso 2 Focuser + Astromechanics Canon Focuser
Does nobody have the same issue? Can someone from the developers confirm this?
Cheers
Amin
Skywatcher Newton 200/1000, Sharpstar 60ED, Canon Lenses
Skywatcherr EQ-6 R, AZ-GTI
StellarMate @ Raspberry Pi 3B+
ASI 183 MC Pro
ASI 290 MC guiding cam on APM 60 ImageMaster
Sesto Senso 2 Focuser + Astromechanics Canon Focuser