OK, second test.

Same test setup: A profile with only the telescope simulator and the QHY CCD driver as main CCD (not as guider)
I performed this sequence of events:
• In KStars open the EKOS - Kstars dialog (Tools|Ekos or Ctrl+K)
• Start the profile
• Without any further use of the driver: Disconnect-Connect succeeded
• Using the INDI Control Panel: Expose test with times ranging from 0.0001 till 100 sec. All successful
• Using Preview in Ekos - Kstars CCD & Filter Wheel: Expose test with times ranging from 1 till 100 sec. All successful
• In the INDI Control Panel: Disconnect and Connect
• Using Preview in Ekos - Kstars CCD & Filter Wheel: Preview a picture with 1 sec failed
• I stopped the Preview using the little stop button below the Sequence Queue window
• In the INDI Control Panel the led next to Expose is still yellow, the times are both 0.00

Log attached

regards berendj

Read More...