Hello. I am using EKOS Scheduler to image 3 targets, repeatedly, throughout the night. I have setup as follows:

Job1: Target 1
Job 2: Target 2
Job 3: Target 3
Job 4: Target 1
Job 5: Target 2
Job 6: Target 3
Job 7: Target 1
Job 8: Target 2
Job 9: Target3

And so on, repeating the Target1,Target2,Target3 jobs until Job 36. Is there a simpler way to do this than to actually input 36 jobs? Can I set 3 jobs in the Scheduler (Job 1: Target1//Job 2:Target2//Job 3: Target3), and then ask it to loop through that set of jobs 12 times?

I have tried to use the "Repeat" buttons on the Job Completion menu within Scheduler; however, these cause an individual Job to repeat before moving on to the next. It's important for me to force imaging of Target1,Target2,Target3 in that order before repeating to the next cycle of imaging for Target1,Target2,Target3.

On a related note, is there a way to set more than 20 Priorities, so I can force an order for 36 jobs to run in order 1,2,3,4....all the way to 36 ?

Thanks much for the help!

I have
3 targets, and then go back to target 1

Read More...