I have been progressively trying to make my rig more autonomous so I can leave it out a whole night unattended, and one of the hurdles I need to overcome is the meridian flip.
My mount is an EQ-5 with Onstep, and I run Astroberry on a RPi4.

It seems like the LX200 driver only allows the mount to go to HA=0, but not past. It just stops tracking once it reaches that point. This means that the criterion in the mount module in Ekos is never reached, so the meridian flip never happens, even when I set a meridian flip at HA=0 or degrees=0. In the indi panel, it's possible to set an offset to stop the mount from tracking BEFORE it reaches HA=0, but this offset does not allow negative values to let the mount go past HA=0.

What I can do, however, is to set 'AutoFlip=on' in the LX200 indi panel, but the issue there is that it doesn't communicate with Ekos at all. That means the mount does not wait until the exposure is done, and it does not check alignment once the flip is performed.

Anyone else with this issue, or someone who has found a way around this issue?

Read More...