Hi everyone,

I'm trying to use a Starshoot Autoguider Pro as a guide camera, but haven't had any luck connecting to it through Ekos. Has anyone else had success with a particular driver or any file mods to make it work?

I've tried the following drivers:
- indi_ssag_ccd
- indi_qhy_ccd
- indi_starshootg_ccd
- indi_sx_ccd (really stretching here)

I'm running the drivers remotely on a RPi 4, connecting via KStars/Ekos on a Windows computer (both with Pi as a hotspot and over a router). I've tried using the Pi4's USB 2.0 and 3.0 ports with no discernable difference. I've previously connected other cameras and a mount to the Pi and successfully controlled them, but for this test, I only have the SSAG Pro connected.

In each case, I get the following prompts, respectively:
- "Failed to connect loader." "Failed to connect device." (two separate prompts)
- "No QHY cameras detected. Power on?
- "No Toupcam detected. Power on?"
- "Unable to establish remote device" (not a pop-up like the others, but in the Ekos status window)

If needed, I can post logs, but if anyone has made it work, I'd like to give their config a try.

Thanks!

Read More...