Hey all,

While running my Raspberry Pi 4 with the EQMOD driver, ZWO CCD driver for my imager, and ZWO CCD driver for my guider, I run into a problems sometimes with image acquisition. My imager is a ZWO183MC and the guider is a ZWO120MM mini.

If I go to capture an image using Ekos and select the ASI120, I can take a picture no problem and the FITS viewer shows up immediately. However, if I try to capture using the ASI183, often it will behave as though it’s taking a photo, but then it will say something like “recapturing”, and then the INDI Control Panel will display “Error: Image Capture failed after 3 attempts”. If I disconnect and then reconnect to the 183 in the Control Panel and try to capture an image again, it works fine for a while. With Kstars running on my laptop (bypassing the RP4) and the 183 directly connected, it works 100% of the time.

I also run into a problem on the RP4 where, when image capture via the 183 does work, it shows “Downloading...” for a significant period of time, sometimes up to 2 minutes for a single exposure. Could this be a bandwidth issue because I’m using a WiFi connection to the Pi? Would running an Ethernet cable to the Pi help with this?

Read More...