Thank you!

I know wire is more robust but I would like to reduce the amount of wiring. Wireless comes at the expense of more battery, but anyway, I will give WiFi a try.

I am planing to use it for the dome and dust cap, that are used very little during a session, so I expect it will not interfere among other devices.

In the case of the dust cap, it probably requires another approach, as you said, they may be required during a session in case flats or darks are scheduled. In that case, I should orchestrate it properly.

I was more concerned about Ekos requiring the devices to be active during a session, due to any rule. I have seen this flag on the dome to lock it to the mount and the other way around, lock the mount so the dome is open before unparking the mount. In the case of this lock, I think I should run it this way:
1. Power on dome
2. Connect Dome driver
3. Perform dome action
4. Unpark the mount.
4. Disconnect Dome driver (e.g. indi_setprop MyDome.CONNECTION.CONNECTION.DISCONNECT=On)
5. Power off the dome

Will step 4 work as expected? Or should I configure the mount and dome to be unlocked each other?

Read More...