Re:Can I set the default "solver action" in the solver module?

Hi everyone,

Can I set the default "Solver Action", like as "Sync" in the Solver module in Ekos?
The reason I'm doing this is that I mostly perform platesolve and sync where the telescope to point to, and then perform a goto to the target.

I was hoping I can set the "Sync" and save it as the default so every time I start Ekos it would start as "Sync" instead of "Slew To".
Thanks!

Should be doable to add an option here to store the last state of this button group, yes. However, Scheduler does change that value by itself when running, so we must restrict the option update to end-user action, which is slightly less straightforward.

-Eric

Thank you Eric. This would be a nice-to-have feature so I won't accidentally slew my mount (especially to some wierd position like pointing under the horizon) after platesolve.
Or may be in the UI, consider adding "Ask Me what to do", so this would pops-up, ask the user to make sure it only applies to the UI interactions.
Thanks for considering my suggestions!

Apart from what Eric indicated, the polar alignment routine sets it to "Do Nothing" so if you use that routine then you will have to set it to Sync manually afterwards.


Wouter