×

INDI Library v1.9.3 Released (11 Nov 2021)

Bimonthly Stable INDI Library release introduces new drivers and fixes for existing ones. Some highlights:

QHY294M camera with QHYCFW3S-SR filter wheel ?

  • Posts: 15
  • Thank you received: 1
Hi Nick, here is what I get from dmesg with connected FW:

[ 2.513647] usb 1-1.1: new high-speed USB device number 3 using xhci_hcd
[ 2.654591] usb 1-1.1: New USB device found, idVendor=1618, idProduct=c296, bcdDevice= 1.00
[ 2.654613] usb 1-1.1: New USB device strings: Mfr=1, Product=2, SerialNumber=3
[ 2.654631] usb 1-1.1: Product: WestBridge
[ 2.654648] usb 1-1.1: Manufacturer: Cypress
[ 2.654664] usb 1-1.1: SerialNumber: 0000000004BE
[ 6.000733] usb 1-1.1: USB disconnect, device number 3
[ 6.153968] usb 2-1: new SuperSpeed Gen 1 USB device number 3 using xhci_hcd
[ 6.195279] usb 2-1: LPM exit latency is zeroed, disabling LPM.
[ 6.196336] usb 2-1: New USB device found, idVendor=1618, idProduct=c297, bcdDevice= 0.00
[ 6.196362] usb 2-1: New USB device strings: Mfr=1, Product=2, SerialNumber=0
[ 6.196385] usb 2-1: Product: QHY294P-V210220
[ 6.196402] usb 2-1: Manufacturer: QHYCCD

Seems to be exactly what you get.
Regards
Stefan
3 months 3 weeks ago #74161

Please Log in or Create an account to join the conversation.

  • Posts: 53
  • Thank you received: 1
Thanks Stefan. I can't think of anything else that might be different (apart from no FW appearing in my setup) ?
Cha (qhy guy) seems keen to do something but progress slow due to 8 hour time diff on emails........
Worst case I will attach a mini hub to FW and use USB mode - same setup as when I use ZWO EFW.....
Nick
3 months 3 weeks ago #74162

Please Log in or Create an account to join the conversation.

  • Posts: 15
  • Thank you received: 1
If the FW works via its USB connector then there might be a problem related to the 4-PIN connection between the FW and qhy294.
Maybe the cable or one of the connectors are broken or there is something disconnected inside of the cam or the FW.
Chan should know ways to verify that.
Stefan
3 months 3 weeks ago #74163

Please Log in or Create an account to join the conversation.

  • Posts: 53
  • Thank you received: 1
Hi Stefan. Yes it seems very lkely. It's just same as when I connect the camera without the FW.
No comms to FW via camera. I've checked the cable for continuity - all pins seem to be connected to the RJ12 so either problem inside camera or inside FW.........
My ZWO EFW (5 slot used with colour cam): plugged it in and it worked - end of story.......
Nick
3 months 3 weeks ago #74164

Please Log in or Create an account to join the conversation.

Time to create page: 0.596 seconds