Hello,

I seem to remember that I could set up my 'flip flat' to run a specific value when I ran flats... that option seems to be gone now. So the process is to manually go into the INDI driver... turn on the light source... set the brightness.. and then take pictures? Is there a better way that I can setup inside of EKOS as a sequence? If I wanted it to take flats via scheduler... how would I do that?

Thanks,
Chris

This is done in the Capture module, not scheduler. If you select Flip Flat as the cover + light source in your optical train then the process is automatic when you capture flat frames. Ekos controls the exposure time and not the brightness level. You can however configure different brightness levels per filter, so when INDI detects a filter change, it would alter the brightness level applied.