The new Firmware 4.0 may have a bug, or the INDI driver needs some updates. Something is broke.

I am using KStars 3.5 and Nexdome Firmware 4.0. Here's what problems I have been over the last two days:

- The dome still has a problem when I send my mount to the HOME position (zero az.). As soon as the dome slews to zero, it then waits a few seconds and then goes off and slews to 270. After a few more seconds it goes back to zero and this repeats until I either turn off SLAVING or I move the mount to any other location.
- The shutter keeps crashing after a few minutes of use. I have to cycle the shutter power off and back on, and then use the manual button to close it.
- The Nexdome driver can't seem to hold any settings I type in and even I write them two the EPROM. This includes the rotator acceleration and velocity speeds, and the slave configuration measurements. I fill them in, and choose to save them to EPROM. It appears to work. But then after I log off and back in, the settings are back to zero!

NONE of the above issues happened with the previous version of the Nexdome firmware (3.3). They are all new after upgrading to 4.0

Read More...