I've tried to use ASTAP solver, but when I want to choose it it tells me that it isn't installed. How to install it?
Also I've tried doin Polar alignment in ekos, but it can't solve view from my guiding scope (ASI120MC clone and 130mm focal lenght), that's why I wanted to try solve it with ASTAP in Ekos. Okay, so I've used my 6D with 200mm lens and it solved. I've done the polar alignment process (with manual slew) and after correction I've done it again just to see what PE error I had after this and it shown higher error than before so without correcting I've done the process again to see if it will show the same error and no, it shown way differen PA Error. Why?
??? You have to point the telescope to the object you want to see/image. The 30 degrees is a search limit. If will search in a spiral from the initial position till it is 30 degrees away maximum. You could also select 180 degrees to search whole sky.
The solve will tell you where the telescope is pointing to. I can't advice you on a manual mount.
Roughly 30 degrees is adequate, a little more or less is not an issue.
INDI/KStars on Raspberry Pi 4, 4gb
Raspbian Buster with AstroPi3 script configuration
Skywatcher HEQ5 Pro Mount
Canon 600D Camera
Orion SSAG/ASI120mm @280mm Guide Scope
Waveshare Stepper Motor Board - DIY Focuser
Adafruit GPS Module
Generic Bluetooth Joystick.
Startech 7 port powered USB Hub.
I think its a known bug in polar alignment. If your PA error gets bigger after polar alignment then you have to put the circle on the star, not the end of the line (opposite of what you are supposed to do) I always do it this way and 9 times out of 10 it works.
RPi 4B (4gb) running Stellarmate OS
Skywatcher Quattro 250 with f4 coma corrector
Skywatcher Evostar 80ED with 0.85 reducer/flattener
ASI1600MM Pro with ZWO 8x1.25" EFW,
Guide scope 50x190mm, Guide camera ASI290MM
ZWO EAF focuser